The ignition switch is located on the steering column just above the brake pedal. it has 2 screws holding it in place. You will need to take the entire steering colum off. Pull the wiring harness out.. it's a real pain. I own a 1970 SS 396 cowl induction, factory air, everything stock. It's an orignal.
== == Your car has a Rack and rod setup. When the key is turned it pushes the rod down the steering column and slides the ignition switch into the position you want. To replace it you need to remove it from the bottom of the steering column. There should be either two screws or a clamp.
Key is on steering column--control rod is connected to switch on lower end of steering column by brake pedal
replace it
It is inside the distributor.
You will need to remove the retaining ring at the top of your 1979 Chevrolet El Camino ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
wiring diagram ignition switch el camino 71
The dimmer switch is located on the bottom of the steering column,just remove 2 bolts and it unplugs from the wiring,very easy to replace. Most auto parts stores sells them for around $15.00 bucks. Good luck!
You need to purchase a Haynes Manual that is specific to your car. It will have more information than you will ever us.
remove the steering wheel and the turn signal mechanism. Then there is a screw right in front of theignition. Remove the screw and pull out the ignition. Should take no longer than 30 to complete from start to finish.
i need to no the color codes to a 1976 el camino ignition
all 1984's had HEI ignition.
The 1985 Chevrolet El Camino ignition switch can be removed by loosening the retaining ring at the top of the switch. The switch will slide out. Remove the wiring harness from the back of the ignition switch.
how to replace a starter