Want this question answered?
replace the rubber o rings u may have to replace the injector if its leaking fuel through it
replace the "o" rings
Remove the fuel rail, the injector just pulls out. Make sure area is very clean. Replace all o-rings.
remove two torx screws that hold down the bracket which hold down the injectors. then you can pry out the injector whit an screwdriver but becareful not to damage the injector or o-rings
its quite simple just unbolt the fuel rail which is the line plugged into the top of the fuel injector then unplug the wiring to it, lift up on the fuel rail and pull the injector out make sure that when you replace it, that you replace the o-rings at the top & bottom of the injector and slightly lube with clean oil
Code 45 is an Injector leak. You can replace the injectors or just the O-Rings.
bullnose pliers to remove the clip, and remove the fuel rail, replace the O-rings on the injectors, and press them into the intake, then the rail, then replace everything you had to remove
you must remove the throttle body, remove the seal and harness grommet, then the injector cover. then with the throttle valve held open tap the injector with a hollow bar being careful not to damage it. remove o rings and disconnect from wiring harness.. when reinstalling remember to coat the new o rings with silicone
How do you replace a fuel injector on a 2001 Mazda mp
Replace the bad injector.
WELL THE INJECTORS ARE LOCATED IN THE REAR PART OFTHE ENGINE ALL YOU HAVE TO DO IS REMOVE THE WIRE,UNSCREW TWO LITTLE PHILIPS SCREWS TE ONES AT THE TOP OF THE INJECTOR THEN CAREFULLY PULL UP THE INJECTOR AND WHEN YO ARE PUTTING BACK THE NEW OR REBUILT INJECTOR TRY TO PUT SOME VASELINE IN THE O-RINGS OF THE INJECTORS OTHER WAY YOU WOULD DAMAGE TE O-RINGS
Replace the O-ring on the injector.