there should be three screws holding the door panel on. one behind the handle one under the bottom and i think one behind the window control panel which just pops out. Lift the panel up and out after removing the screws.let the window down to reveal the bolts holding to power unit. remove the bolts tilt window lift up and out the window opening. Should work.
I am having the same problem with my driver's side window on my 2000 Astro. It is intermittant. It seems to always go down, but sometimes it will not go back up. So far, if I turn off the engine and restart, then the window will go back up. (Maybe a coincidence.)
u must remove the door panel and pull the sound sheet {plastic} off next locate motor which should be near the bottom right of the door drill out the rivits and pull motor out un plug then reverse all directions to reinstall
the panel on the door must first be removed youll see the motor there with screws holding it against the door remove the screws and remove the motor there are ball bearings in the motor that some times fall apart unabling the motor to do its job good luck
when you get the door panel off the window regulator is rivited in from the factory you will have to knock the steal pins out of the center so you can drill the rivit don't do what i did be shure to block or do somthing to hold the window to keep it from falling and break something else. then you can get the regulator out to get to the motor. you will need a 1/4 drill bit to drill the rivits and some bolts to reinstall the regulator mine had 4
Hi, you remove the interior panel then the plastic cover then remove bottom motor plate cover. put a screw driver in one of the open holes or some how keep window up so it doesn't come down. unplug the motor. get an 11 mill open end box wrench and remove 3 little bolts behind the window regulator. one is at a 9 o clock position one at 6 o clock and one at 3 o clock. remove bottom regulator bracket rivet or loosen bolt and wiggle the motor out. grease gear teeth and reinstall motor hold in position with one hand install plate cover and the 3 small bolts with the other hand, one by one tighten up and also tighten up the bottom regulator bracket bolt. reinstall plate motor cover and reverse the easy procedure. HOLLA! Edgar Soto 1981 Custom Daytona Twin Turbo Greenwood Corvette Stingray Orlando, FL. 32822
remove door panel assembly
some models are cable driven and require replacement of entire regulator assembly
if not cable driven then you can replace only the motor itself
each vehicle is different
some are bolted in place and others are riveted to the door shell and require cutting or drilling the rivets out
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
How do you replace a power window motor ( rear passenger side ) in a 2002 Ford Explorer
You can find the window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
You will have to replace the regulator assembly.
I just bought a Pontiac Montana 2004 and dont know how to close the rear windows
windshield trim loose and Pontiac issued a bulletin for right side window trim.
cannot get old ribbon rfom slide
You can find the 1994 Pontiac Firebird window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
How do yo fix a stuck driver side electric window on a 1998 pontiac firebird.
Change the motor. These cars are notorious for this.
rear window defroster relay in a 97 Pontiac firebird
no
The motor is mounted with rivets, you must drill out the rivets. The bolt must be short enough so that the window arms will not touch, this will cause the window to not go up or down all the way.
This site has a step by step guide for an older Firebird, but it is identical to what you need for a 2001. http://shbox.com/page/windowmotor.html
u have to remove the drivers window and remove the regulator assy...once its out there ar 4 rivits u have to drill out be very carefull of th spring in the regulator it will come out and injure u if u don't take the proper precautions
You have a stripped gear inside the door.
behind the drivers door window
the relay for the drivers power window is up under the dash to the right of the gas pedal just in front of the center console
Bcm is going bad