For the quarter panel light assembly, when prying, you need to apply the prying tool towards the front of the assembly (i.e. further away from the two 10mm bolts), top and bottom. Pulling the assembly straight out away from the car body). Worse comes to worse, you can use self-adhesive velcro as a replacement if you snap off the plastic tabs.
For the assemblies that are on the rear hatch, you have to remove the inner body panel by removing the one 10mm bolt in the middle of the panel, and the two 10mm bolts that are used on the hold bar. Then just pull the panel off the body, you can't damage anything when removing it so just pull it. Both tail light assemblies are then fully accessible from the rear. Do NOT try to pry off the light assemblies on the rear hatch, they are bolted from the inside.
How can you manually release the emergency brake on the 1998 Toyota Sienna?
You will need to bleed the brakes, starting from the caliper furthese from the master cylinder then moving closer.
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next, put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
The Toyota Sienna should have high and low marks on the side of the brake fluid reservoir. Check to see that the fluid level is between the two marks.
i just had the northridge Toyota resurface the rotors and changed the brake pads of my 05 sienna for 199+ tax... they are having some kind of brake special going on.
Um... Aren't all brake lights in the back of a car?
14mm
"http://wiki.answers.com/Q/Where_is_the_brake_fluid_indicator_on_1998_Toyota_Sienna"
Manual says DOT 3
Lift the vehicle, remove the tire and set it aside, remove the brake shoe/caliper, and remove the old brake pad. Throw away the old pad, put in a new brake pad, replace the brake shoe/caliper, replace the tire, tighten the nuts, and lower the vehicle.
check the fuse that's if the bulb is not burnt out.
how to replace brake fluid on a 1999 Toyota 4runner