0
Its very easy and you will save $$. My dealer wanted $45 for what turned out to be a 5 minute job and $1.99 for 2 license plate bulbs from the auto parts store! That gave me the motivation to figure it out myself! Here's how you do it: With a flat head screwdriver, slide the flat head under the lens of the license plate light FROM THE DRIVERS SIDE. Why the drivers side? Because the metal clip holding the lens & bulb assembly to the vehicle is on the drivers side on BOTH license plate lamps. Work the flat head into the lens and the lens and the attached bulb assembly will come away from the vehicle. The bulb is held in by 2 contact plates. Push on one of the contact plates and the bulb will come free. Replace the bulb and push back the entire assembly into the vehicle. I also used a pair of pliers to help remove the assembly from the vehicle.
What else can I help you with?
How do you replace the license plate bulb on a 2004 Honda cr-v?
how to replace the license plate bulb on a 2004 Honda cr-v
How do you replace license plate bulb on 2004 crv?
how do you replace a honda crv licence plate bulb on a 2004
How do you replace the license plate light bulb on a vw?
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
What is the replacement bulb for license plate on a 2001 Ford Focus?
The 2001 Ford Focus Owner Guide shows : ( C-5W , license plate lamp )
How do you replace the license plate bulb on 1999 Cadillac eldorado?
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
How do you replace license plate bulb on 2002 Toyota Sequoia?
To replace the license plate bulb on a 2002 Toyota Sequoia, first, open the rear hatch and locate the license plate light assembly above the license plate. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reassemble the cover by snapping it back into place. Finally, test the new bulb to ensure it's functioning properly.
How do you replace the license plae bulb on a Mazda tribute?
You need to unscrew the whole cover panel for license plate.
How do you replace the license plate bulb on a 2005 Lexus RX330?
Ask your car dealer...
How do you replace Volvo v70 license plate bulb socket?
You need a torx screwdriver....
How do you replace license plate bulb on 1999 ford contour?
you buy a new one
How do you replace the license plate bulb on 2000 Mercedes S430?
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
How do you replace license plate bulb on 2003 Chevy Tracker?
To replace the license plate bulb on a 2003 Chevy Tracker, first, locate the license plate light assembly at the rear of the vehicle. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise and then replace it with a new bulb, ensuring it’s secure. Finally, snap the lens cover back into place and test the new bulb to ensure it works.
