You need a torx screwdriver....
Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
The license plate light bulb on a 2002 Pontiac Grand Prix is replaced by removing the retaining bolts and pulling the bulb out of its socket. A new bulb is then put into the socket and reassembled.
unbolt lens, remove bulb socket quarter turn
Unscrew light from bumper. Turn socket 1/4 turn counterclock. Pull socket out of cover. Pull bulb out of socket.
To replace the license plate light on a 1991 Volvo 240, first, locate the light assembly, which is typically found above the license plate. Use a flathead screwdriver to gently pry off the plastic cover or lens. Once exposed, remove the old bulb by twisting it counterclockwise and replace it with a new one, ensuring it’s securely in place. Finally, reattach the cover and check that the light is functioning properly.
To replace the license plate light on a 1999 Volvo S80, first, locate the light assembly at the rear of the vehicle above the license plate. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reattach the lens cover. Finally, test the light to ensure it works properly.
Open the trunk. Turn the socket counterclockwise and remove. Then gently pull out the light bulb. Place the new bulb in the socket and replace the socket into the lens by turning clockwise. Replacement light bulb #3652.
This is an easy one, but.... I spent a good half an hour figuring it out. The license plate lamp requires no tools to replace. Above the license plate is a small bulb housing. At the back of the bulb housing is the bulb socket that locks into place. Simply turn the socket 90 degrees moving the socket clockwise as you're facing the rear of the car and wiggle it out. The bulb simply pulls out and the new one pushes in!
THRU THE TRUNKThe tail lights are replaced through the trunk. The license plate light is replaced by eitherundoing the two screws that flank the light,pulling the fixture down,removing the bulb socket,replace the bulb and reverse to reassembleORreach up from under the bumper to remove the bulb socket,replace the bulb and return the socket.If you don't know where the socket is, or don't have a flexible wrist, it's easier to undo the screws
From inside the trunk,twist the socket counterclockwise to remove the socket...
The following Instructions are for all 1991, 92, 93 DeVille Sedans and Coupes.Remove rear license plate.Remove 4 nuts underneath license plate.Separate license pocket (with reverse lights) from body.Remove license plate lamp socket from license plate pocket (1/4 turn counter clockwise)Pull bulb (straight out) from socket.Push new bulb into socket (line up blade to slot in socket).Install license plate lamp socket to license plate pocket (1/4 turn clockwise)Install license pocket (with reverse lights) on to body.Install 4 nuts underneath license plate.Install rear license plate.