my husband says there isn't one
Inside the steering column behind (connected too) the ignition key switch
The cylinder should not be worn out on a 99 car unless you were using a very heavy key chain. I would just replace the ignition switch if the cylinder works OK. You also might try some Graphite lube on the cylinder.
If you take the vin number and proof of ownership you can go to a Chevrolet dealer and they can cut you a new key. I kinda think the OP is asking how to remove the Ignition Switch. You need the key to remove the switch without drilling and making a mess of the housing.
You cannot bypass or reset the Securilock anti-theft system on a 99 Ford Ranger. If the system begins to malfunction and you can no longer start the vehicle, you will likely need to replace the transponder unit that is located behind the ignition in the steering column.
It cn be the switch, bulbs or wiring. I suggest if you intend to work on your car to get a shop manal on it from AUTOBOOKSONLINE.COM for about $20
please give instructions on replacing the ignition switch on my 99 Malibu
The relay switch for the locks on a 99 Chevy Suburban is located under the driver-side dashboard.
The blower motor is drawing to many amps, replace the blower motor.
I just replaced the front heater motor in my 99 Suburban, it worked great, now the heater/ac absolutely does nothing. Could the switch be bad, the motor, I am stumped and need help. Thanks Jim.
your switch is going out....you may need to replace it
On my 99 Suburban, the alarm activates when you press the lock button on the remote twice.
A 1999 Honda Civic Ignition switch is located under the steering column. Remove the steering column. The switch is seen connecting to the dash harness and lock cylinder. Unplug the switch from both places and replace with a new unit.
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
i need a wiring diagram with pictures to help put my ignition switch back together on my 99 olds intrigue
Inside the steering column behind (connected too) the ignition key switch
The cylinder should not be worn out on a 99 car unless you were using a very heavy key chain. I would just replace the ignition switch if the cylinder works OK. You also might try some Graphite lube on the cylinder.
replace rear brake hydrolics