You need to unbolt the tube, pull it out, replace the o ring, reinstall, and check the fluid level.
You need to unbolt the tube, pull it out, replace the o ring, reinstall, and check the fluid level.
You need to unbolt the tube, pull it out, replace the o ring, reinstall, and check the fluid level.
You add it down the dipstick tube.
How do you replace a transmission solenoid on a 2001 dodge Dakota 4.7 engine 4x4 location?
Examine the dipstick, it should be engraved with the type of ATF required. Mopar ATF+4
AnswerYou add the transmission fluid through the tube at the back of the engine compartment in the dipstick that says trans fluid.
Automatic, you fill down the dipstick tube. Manual, there is a plug that screws out of the side. That is the wrong answer for a manual. The plug on the side is the drain. WHERE IS THE FILL
you fill it up till the oil come the top hole witch is the same hole in witch you put the oil in.
most common is transmission pan gasket, also front and rear seals, or ant sensors. if it is 4x4 the transfer case occasional leaks. least likely is the trans having a crack in it.
The Dodge Dakota transmission blueprint is also known as a transmission diagram. The transmission diagrams can be found at most Dodge dealerships.
your heater core is leaking. Needs to be replaced
what type of auto transmission is in a 89 dodge dakota 3.9
I wouldn't think you could flush a heater core. you can flush a radiator. Heater core you would have to replace if it is leaking or stopped up
same place you put the fluid, Through the dipstick hole on an automatic, through the filler plug hole on the side of a manual transmission it should be a hex type plug about 1/4 way up from the bottom on the left side.