You`ll have to remove the inner door panel. two screws at door pull and pry out the switch panel. the panel is held on by plastic friction pins you will have to pry the door panel off unplug the switch panel then lift the panel(slide) out and up. you will see two nuts inside the door cavity by the handle. first carefully pry out the actuator rod to the lock mechanism then remove and replace the handle.
How do you replace a starter in a 1999 suburban
Take it to the dealer, this is not an easy job. Take it to the dealer, this is not an easy job. I did replace the outside door handle on my 1999 suburban drivers door. It is not a easy job and was very frustrating. Remove the inside door panel. The door handle is held on by two screws. There are also two rods to deal with. one for the lock the other for opening the door. Do not get them mixed up. I was able to get the new handle in with the door lock only partially in the new handle. Then with the new handle screwed in I was able to push the lock all the way into place. Test and replace door panel.
I ran into the same problem with my 99. Turns out the handle is riveted on and has to be done by the dealer. There is a certain tool i guess that is needed. Goodluck
Unscrew a few screws and pull it out
how to replace a exterior front door handle on a 1999 toyota tacoma
Replace it every 75,000 miles.
Answernot hard
How to remove the window motor from the regulator
Replace the windshield wipers.
abs sensors are at the axle hub
youll need to take the door panel off, then unscrew the handle assembly and replace with a new handle ( junkyard?). screw that in then replace door panel.
Replace brake light switch.