You may need a puller to swap the pulleys, I forget, but see if your local library has a manual for free and read up good luck d
you will need a power steering seal replace.
Replace
According to the 2000 Ford Crown Victoria Owner Guide : ( Motorcraft MERCON automatic transmission fluid is used as the power steering fluid )
According to the 2002 Ford Crown Victoria Owner Guide : Motorcraft MERCON automatic transmission fluid is used as the power steering fluid
right next to the engine
Type 'F' ATF.
which one the power steering,alternator,crank or a/c,crank?
You can use the regular power steering fluid from you local auto parts, or use Dexron III transmission fluid. Either is good.
Denise, the fluid goes in the power steering pump resovior at the same place you check the level. Make sure to check the level when the fluid is hot.
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
Driver's side of the engine, just behind & below the power steering pump.
On a 2000 Ford Crown Victoria : In the fuse panel below and to the left of the steering wheel , by the brake pedal ( it has a cover on it ) (fuse # 16 is a 20 amp fuse for the cigarette lighter and auxiliary power point )