How do you replace the rear brakes on a 2000 Toyota Echo?

Answer 1

Block the frontwheels front and rear of tire. Untension the parking break. Jack the car up from 1 side until the tire you want to service is off the ground and place a jack stand under the hard point in the frame, you will see it, then continue to do the same on the other side. Remove the tires and place to the side, they do make good seats. If the hub does not 'slip off' u may have to loosen the tensioner in the lower middle on the inside of the backing plate. I believe the correct direction is up to loosen. after removing the hub u will see how it is 'sprung' together. You may need to purchase a Brake tool from your local Automotive store or if you are thrifty you can use common tools.I use a flat bladed screwdriver to release the spring pressure on the retainers and a pair of needlenose pliers to turn the hold-down nail, works well. You may need loosen the break adjuster quite a bit to make the hub go back on w/ the new shoes pending on how worn the old 1's are.REMEMBER!!! Do 1 side @ a time so you can make sure that the new shoes are properly installed!!! Failure to corectly install break shoes may result in bodily harm and possable death. good luck!