BLOCK THE WHEELS FOR IT WON'T ROLL OVER YOU AND KILL YOU.
Now take the 4 bolts out of the rear drive shaft U-joint, and remove driveshaft and pull it out of the transmission. Now take a screew driver and pry the seal out of the transmission tail shaft. Then take hammer and tap the new seal back in the trans. then put it all back together. YOUR DONE.
No. The 2wd and 4wd trans cases are compleatly different.
Usually located on the transmission.
turbo 350
To make that transmission work. You would have to install a computer and wiring harness and speed sensors. That would be alot of money. The 4L80E is a electronic controlled transmission.
Check out this site, http://www.nadaguides.com/
It should, may have to swap the whole front clip. Resulting in changeing out the core support..
It is in the motor.
A direct replacement, no. But with fabrication and a few bucks it could.
== ==
1976 Scottsdale full size box, 4 WD, I paid $5,500.00 for mine, still have it.
most older trucks can be started without a key
if its automatic then just plain Jane ATF