3 big plastic wing nuts hold the tail light assembly in the body. remove those and the tail light can be removed to gain access to the bulbs.
how do you change a brake booster valve to a 1998 Pontiac transport
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
With a wrench.
When you replace the brake pads also replace the brake padsensor (used sensorwill not turn out lights), then the light will reset itself automatically
replacement of brake light bulb-- open trunk, look on inside of back of tail,brake light housing, there are retaining plastic screw on nuts, maybe covered by trunk lining of fabric. remove retaining nuts and push housing out, have someone to press brakes if not sure of which bulb to replace. locate and twist bulb housing out.
You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.
You don't. You replace the worn out rear break shoes. If that doesn't do it you need to replace the stretched E brake cable.
Either under the dashboard on the driver's side or in the engine compartment.
under dash drivers side mounted above the brake pedal
WHAT ARE THE WIRE COLORS FOR BRAKE AND TURN SIGNALS ON 1999 PONTIAC IN ORDER TO HOOK UP TRAIER HITCH PLUG?Not positive yeLL0w wire Left turn signal, riGht Green wire once you have the turn signal wiring hooked up the brake lights will automatically work because the brake lights work through the turn signal wiring, brown running lights, white ground.
Lift the car, remove the car tires, remove the brake shoe/calipers and remove the old brake pads. Put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
Replace the rear brake shoes with a non-metalic brake lining, new hold down hardware and have the drums turned.