The lamp monitor system on Cadillacs allows the driver to visually check the operation of the exterior lamps without leaving the vehicle. This is accomplished through the use of light conductors (fiber optics). The conductors are used to transfer light from the individual exterior lamp to its respective monitor. The system does not use electrical power in order to operate, nor does it have any moving parts. 1. Check bulb in lamp connected to inoperative monitor. 2. If bulb is burned out, replace bulb. If lamp operates normally, proceed with further checks. 3. Check for proper installation of conductors to sealed beams or lamp housing. 4. Check conductor harness mounting to lamp monitors for proper attachment. 5. Check conductor harness routing for pinched or severely bent condition. 6. If none of the above checks reveals the inoperative condtion, the conductor light fibers have been damaged. Regards, Mike Caldwell
Push in and turn.
Under dash on top of steering column
not sure
Located on left side of steering column. Take off both covers and you will find the turn signal relay.
Remove steering wheel and signal switch
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
under the instrement panal, near the steering column
Front seating area, driver side, under dash, mounted on passenger side of steering column.This is true and exact information but that is the location of the emergency flasherfor the hazards.Where is the TURN SIGNAL FLASHER located? where is tha turn signal flasher?
theres a micro switch like hinge in the sterring colum that make it do that. replace and move on
its by the steering wheel colum you might have to remove the panel to get to it. you should find it if not email me erhack93@yahoo.com
Hello yes there is two signal flashers on the 2000 eldorado take the cover off from under the dash under the steering wheel one is silver to your right the other is to the left sitting in the corner a black little box.
the turn signal switch is probably bad