answersLogoWhite

0

  • Headlights Tail and Brake Lights
  • Ford F-150
  • Turn Signals and Hazard Lights

How do you replace the rear turn signal light bulb on a 1996 Saturn SC2?

User Avatar

Wiki User

βˆ™ 2006-07-24 12:51:31

Best Answer
Copy

I'm answering my own question. Since I didn't get any response, I spent some time looking the car over and found the following: When you open the trunk, theres a plastic cover over the side of the tail light assembly. It's held in place by two plastic expansion plugs. These are the type that get forced through an opening and expand slightly on the inside to keep them from backing out. You can attempt to pry them out but be prepared to replace them since the manufacturers like them to break so that you have to buy replacements. I was lucky and was able to pop the top one out without it breaking. I left the bottom one in and just bent the plastic cover back so that I exposed two screws that held the assembly in place. You need a star-shaped bit to unscrew it, since it's not a conventional phillips-head or slot head screw. Once you've done that, you can unseat the whole assembly by pulling on it at the point where it wraps around the fender. Removing the bulb is a piece of cake by comparison.

2006-07-24 12:51:31
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How do you replace the front turn signal light bulb on a 1996 Saturn SC2?

rear you use a torx driver to remove taillight assembly screws. them replace bulb.


Why doesn't your turn signal blink in your 1996 Honda Accord?

If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.


How do you replace a signal light bulb on a 1996 Lincoln continental?

If its the same as the mark viii then you would have to replace the bulb by removing the light that is held in with 4 or 5 screws then you can take out all wires and bulbs you need to.


In a 1996 Saturn Sl2 which light is the brake light in the tail light assembly?

the two top ones.


Can you replace a 96 Saturn engine with a 92 Saturn engine?

YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE


Replace high beam switch 1996 Subaru outback?

how to replace high/low beam, turn signal lever on 1996 subaru outback wagon


How do you fix a Turn signal for a 1996 Geo Metro?

If the turn signal bulbs work but just do not flash, replace the Flasher Relay.


Intermittent starting 1996 Saturn?

Solenoid going bad remove and replace starter assembly.


Where is fuel pump in a 1996 Saturn?

Inside the fuel tank.Removal of the tank is necessary to replace the pump.


How do you replace turn signal switch 1996 dodge caravan?

To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.


How do you replace 1996 Saturn timing belt?

how do i change timing chain on 95 saturnsc1 1.9 sohc


How do you repair a 1996 Saturn head gasket?

The only repair for a blown head gasket is to replace the gasket.


Selling price of a 1996 Saturn?

Selling price of a 1996 Saturn?


How do you replace transmission fluid in a 1996 Saturn?

Drain the fluid just like you would the oil. replace the filter the exact same way also


How do you turn off the service engine soon light on a 96 Saturn?

On 1996 and later model Saturns you must read the codes with a hand held scan tool. When the problem is read and fixed the light will go out. It's probably the O2 sensor, replace that and the light will go out.


Does the 1996 Saturn SL2 fender fit the 1996 Saturn SC2?

NOT AT ALL


Map light replace bulb in 1996 Toyota Camry?

To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.


What does code Po717 mean for a 1996 Saturn sl 1?

Trouble code P0717 means:Input/turbine speed sensor circuit,no signal


How do you change the front turn signal bulb on a 1996 blazer?

The front turn signal on a 1996 Blazer is accessed by using a Philips head screwdriver to remove the wheel well cover . Locate the bulb and twist to the left, remove. Replace with new bulb and replace the wheel cover.


1996 Saturn what refrigerant should you use?

A 1996 Saturn vehicle will only use R134A refrigerant. I was a Saturn technician for years in Saturn Dealerships.


How do you replace tailights on a 1996 Saturn?

Each tail light is held in by 2 torx screws. They require a torx bit to remove them. Open up the trunk and you will see them on the frame left and right side -RC-


What is the torque sequence for rod bearings for a Saturn 1.9 sohc?

how to replace the rod bearings in a 1996 saturn 1.9 still in the car


1996 Saturn SL1?

timing for spark plug wires for saturn sl1 1996


How do you change check engine bulb 1996 Saturn?

How do you change bulb on 1996 saturn


Can you replace the turn signal switch on a 1996 Mitsubishi Montero without removing the steering wheel or airbag assembly?

no.