Chrysler Cirrus

How do you replace the spark plugs in a 1999 Chrysler Cirrus?

171819

Top Answer
User Avatar
Wiki User
Answered
2006-11-05 12:44:16
2006-11-05 12:44:16

First of all you can get to the first 3 plugs very easily. The other three you have to take off the plenum (be sure to replace the old plenum gasket)

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


You have to remove the upper intake manifold.




You have to remove the upper intake manifold.


Where is number 2 spark plug on my 1998 Chrysler Cirrus 2.5


There are six spark plugs. They are located under the plug wires through the top of the valve covers.


Changing spark plugs is an important task. To do this, disconnect the battery and spark plug cables, and remove the old spark plugs. Next put in the new spark plugs, and reconnect the spark plug cables and then the battery.



You have yo remove the intake manifold(plenum),Go to your local auto parts store and get a haines manual.It will describe everything in detail.


Remove the spark plugs with a 5/8 deep well socket. Turn the socket to the left. Tighten the new spark plugs by turning socket to the right.


My Chrysler 300 SRT8 with a 5.7 Hemi has 16 spark plugs


How do you replace the spark plugs on a Peugeot 307?


Are you sure you need to replace it? Is it a no-spark condition? Might want to check the Crankshaft Position Sensor first.


How to replace spark plugs in a 1989 jeep cherokee?


why is the spark plug full off oil


Maybe when they put the spark plugs in they were not gapped right or they maybe the wrong spark plugs.


Take old spark plugs out put new spark plugs in


how to replace spark plugs on 2006 camry LE


They are located through the center of the valve cover.They are located through the center of the valve cover.


To replace the rear spark plugs of a 2007 Arcadia, you will need to lift the car and replace the spark plugs from the bottom. You will also need to lower the front cradle for proper installation. This will allow easy access to remove and replace the spark plugs.


The spark plugs are 100,000 mile plugs. You need o replace them with platinum plugs, then remove the throttle body and idle speed motor then clean them and reassemble it. There are no spark plug wires on the 3.5L engine.


It is important to replace old spark plugs to keep a car engine running well. To replace them disconnect the battery, remove the cables, remove the old spark plugs, replace with the new spark plugs, replace the cables in the correct order, and connect the battery.


They come from the factory with platnium plugs. The factory recomends changing every 100,000 miles


You should replace the spark plugs when your car won't start first time but does eventually.


A Toyota Allion has 4 spark plugs. These spark plugs are not hard to replace, and can be found in the engine, under the hood. After 2008 models, they are harder to replace.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.