Acura Legend
Toyota Tundra
Ford F-250

How do you replace the starter on a 1993 Acura Legend?

202122

Top Answer
User Avatar
Wiki User
Answered
2008-05-29 03:02:20
2008-05-29 03:02:20

must lower the exhaust system

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the obd1 plugin on a 1993 acura legend

No only 20 inch rims fit in a 1993 Acura Legend

A 1993 Acura Legend requires 24 ounces of R134a refrigerant to refill the air conditioning system. This is applicable to all engine types for the 1993 Acura Legend.

The oil drain plug on a 1993 Acura Legend is 14mm x 1.5

it depends on the shop but it takes 6.3 hours

how to replace starter 1993 88hp Johnson outboard

I do believe it is the same body style and most things should transfer over to the 1993. It may have some electrical differences but not many. You can also transfer parts from a 1994 Acura Legend.

To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.

There is no fuel pump reset button on a 1993 Acura Legend. Thee is a fuel relay which is located under the dash of the vehicle on the driver side.

bolt pattern for 1993 toyota celica starter

You can find the heater core behind the kick plate in your 1993 Acura Legend. Remove the water hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

The 1993 Acura Legend has a timing belt. For 1991-1994 model years, the manufacturer recommends that the belt be replaced every 90,000 miles or 72 months.

Started is located on the drivers side on the engine behinde the AC compressor. You will need to raise the car and access it from the bottom (real fun to change)

The 1993 Acura Legend fuel pump relay is located on the firewall in the engine compartment. The fuel pump relay will be on the passenger side of the firewall.

we have 1993 acura legend it hard up it 4 to 5 times to start up when it start it will start up e.z i mean when engine warm up any body have any idea ?

On the passenger side-Under the ECU cover.. On he

Remove the positive cable from your 1993 Mercury battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

trace the lower radiator hose to the engine, that's where the thermostat located.

Turn off alarm with ignition key in the driver's door.

its under the intake manifold if its a northstar

Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.