No vehicle year was given so I have to keep it general... Ford Explorer Sport turn signal / brake light bulb lamp replacement: Purchase the correct replacement turn signal / brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement turn signal / brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for turn signal / brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
If the bulbs and fuses are fine, it must be your brake light switch attached to the arm on your brake pedal.
3157
check light bulbs and fuses. light bulbs have 2 elements in them, one for stop and one for running. if thses are ok, replace brake light switch on brake pedal
Remove the tail light housing and replace the bulbs.
the screws come off and you replace it
Could be, a blown fuse, burned out bulbs, bad brake light switch, or an improperly installed brake light switch.
AnswerThe bulbs for the brake lights are usually separate from the normal tail light bulbs. Check and replace the brake bulbs first, and if they are still not working examine the fuses, switch and wiring.
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
The light assy has to be removed to take the bulbs out.