To replace the tail light bulbs in a 2000 Dakota open the tail gate. You will find two screws on each side that hold the tail light assembly in place. Unscrew these two screws then pull the assembly straight back. There are two pins holding the assembly so do not pull to the side they must come straight back.
its three screws. and threw plugs
The daytime running light module on a 2000 Dodge Dakota is located underneath the hood. It will be located on the inner fender on the left side.
There are many types of warning lights on the Dodge Dakota. In order to know what a specific light means we need to know which light it is and what year the Dakota is. 2000
The towing capacity of a 2000 Dodge Dakota V6 is about 7500 pounds. The Dodge Dakota was discontinued in 2011.
how do i find out if i have ABS on my front wheel bearing , on my 2000 dodge Dakota quad cab 2 wheel drive
Alternator going bad..replace it. Just had the same thing on my 2000 neon
Dodge does not have 4.3L engine. A 3.7L was not used in a 2000 Dakota. So no.Dodge does not have 4.3L engine. A 3.7L was not used in a 2000 Dakota. So no.
On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. You can then remove the bulb socket and replace the bulb. On my 2002 Dakota Quad Cab there are 2 torx screws.
Unbolt the old ones and put the new one in.
howdo you change the front axel of a dodge Dakota 2000 4x4
Try the 2000 Dodge Dakota CD player. I hear it fits nicely.
On 2000 Dakota Sport you lower the tailgate and there are 2 Phillips head screws that you remove and the whole tail light module comes out. I don't think you can replace a single lens, you have to pay for a whole new module.
either a bad sensor somewhere, or a connection is disconnected
I need detailed information on how to replace a starter for a 2000 dodge intrepid
Yes. as far as I know.
You remove the compressor and replace the belt with one for a truck with out ac
remove neg. battery cable for 10 min. and reconnect. that should reset the light.
Yes. A 3.9 v6 engine from a 1995 Dodge Dakota will fit into a 2000 Dodge Dakota with a 3.9 v6 engine. You will have to swap the intake and exhaust manifolds along with all sensors and fuel rail though.
There is no difference in a 1995 dodge dakota with a 3.9 v6 engine and a 2000 dodge dakota with a 3.9 v6 engine and you can exchange the newer engine with the older one.
Dodge does not use inertia/reset switches.
If the light is on, it will need checked and diagnosed.
Not without a lot of work. You will need to replace the motor mounts, ECU and transmission. Far from a direct swap.