Want this question answered?
Move the tensioner to release belt (use bolt in center of pulley and move with socket) Then simply remove bolts from block. Reverse to put on new one.
How to change a timing chain in a 1998 Oldsmobile delta 88
You gotta use tools.
Behind the driver, under the vehicle.
go to a mechanic?
The heater core may be stopped up. Try flushing it, or replace it.
Follow these steps 1. Remove Timing belt & Crank Puly. 2. Remove Timing belt cover. 3. Remove Tensioner and its spring & Remove / Replace timing Belt 4. Align Timing Marks as Carnk pully below and Cam Pully to top Mark. 5. Assemble all parts and Enjoy. Regards Ehsan ehsanwah@yahoo.com
On my 1993 Oldsmobile 88, it is number "8"
Where is the starter relay located on the 1996 Oldsmobile 88?
remove the coolent tank and then use the pully to remove the serpentine belt. then you'll be able to see the water pump takes about half an hour tops.
Locate the idler spring tension pully below the power steering pump. The pully is pressing down on the belt and has to be pulled away from the belt so you can remove belt from the power steering or alternator pully. You need a socket that fits the bolt on the tension pully and a socket wrench with a 2 to 3 foot pipe extension. Attach to bolt head, apply counter clockwise pressure enought to loosen belt to allow enough slack to remove belt. Do not get your fingers between the belt and any pully when removing. You might not like it. To reinstall. Route the belt and release the tension again enough to put the belt back on the last pully.
crank or cam sensor...did you already figure it out?