Thermostats
Ford Bronco II

How do you replace the thermostat located on a 1989 Ford Bronco II XL?

484950

Top Answer
User Avatar
Wiki User
Answered
2008-04-10 05:40:03
2008-04-10 05:40:03

Drain coolant. Remove upper radiator hose. unbolt 3 bolts on thermostat housing. take out old one. reverse to install.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.

Follow the top radiator hose from the radiator , where it connects to the engine is where the engine thermostat is located

where is the thermostat located on a 1989 ford tempo

the thermostat is in the front of the block where the bottom rad hose connects.

You may need a universal joint if you are unable to get a socket straight on it due to the belts/fan.

It is located under the driver side headlight.

your thermostat should be located on the drivers side of the engine underneath the distributor behind the inlet for the bottom hose. remove the two nuts and pull the inlet off.

thermostat is located under radiator cap!

The thermostat housing is located at the front of the engine just beneath the distributor.

On a full sized Bronco, it is located in front of the fuel pump between the frame rails near the drivers feet.

The PCM for the 89 Bronco is located on the firewall on the driver side. You can access it from inside the cab, behind the parking brake pedal.

The thermostat on a 1989 Chevy Celebrity is located under the water outlet fitting. Follow the upper radiator hose, it will end at the water outlet.

its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!

The jack should be located under the hood, on the passenger side.

On the interior firewall to the left of the steering column

The thermostat is located at the back of the engine near where the radiator hoses attach. There is a housing held in by two bolts. It may be necessary to remove the air cleaner housing to access it. The new thermostat from Honda comes with the gasket and can only be installed one way (with the pin up).

the thermostat is located on the outlet on top of the motor where the radiator hose is connected. remove the top radiator hose from the housing and there is two bolts holding the housing on the head of the motor, remove the bolts and you will find the thermostat. to replace just reverse the order in which it was taken off. hope this helps. john.

list of fuses for 1989 bronco 2

The thermostat on a 1989 Nissan Sentra is on the front of the motor to the left. It is just below where the valve cover meets top of the manifold. The thermostat is enclosed in the radiator hose at that location.

http://wiki.answers.com/Q/Where_is_the_thermostat_located_on_a_1989_jeep_cherokee"

Usually located in a removable housing at the engine end of the upper radiator hose

The Thermostat is located at the low side radiator hole housing ( one end of the hole is connect from the radiator and the other end is connect to the housing


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.