answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2012-12-23 21:29:04

With engine cool, drain off aprox 2 qts of coolant from the radiator, remove upper radiator hose from thermostat housing, remove thermostat housing, remove thermostat and seal, reverse order to install, make sure thermostat spring is facing into the engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


Follow the upper radiator hose from the radiator to the engine. It is attached to the thermostat housing. Removing the thermostat housing will expose the thermostat.


Will a Chevy blazer engine fit in a Chevy s10 pickup


Evidently pretty hard. My mechanic took 4 hours but he is the slowest most depressing man to watch work....


no the lights mounting area and wiring harness are different. I have the opposite problem a 2000 s10 and bought a 96 radator support



No. Removing the fuel tank from the vehicle is required.


Take out the battery, unbolt and remove the battery tray. This will expose where the ground is. Unbolt that. Replace in reverse order of the above steps.


In the exhaust system, before the muffler.


How do you replace a slave cylinder in a 96 chevey k1500


Why is smoke coming out of my 96 s10 oil fill and exaust blowing grey smoke



The flasher relays are in the back of the glove box the fuses are on the left side of the dash and can only be accessed if the driver's door is open


remove the 2 bolts that hold the thermostat housing to the intake manifold which the upper radiator hose attaches to the housing then just pull the thermostat out and replace.


It should be on the side of the dash just as you open the door.


It is marked on the dipstick what ATF to use.


Need to replace the thermostat with a 195 degree. That ought to do it.


If there is any doubt about it, just replace it, they are cheap enough.



it should be located in the engine compartment,against the firewall.


In our 96 Blazer S10, it was behind the radio. We had to remove the radio to get to it.


That would be the O2 sensor after the catalytic converter.


Goto figure 11 Link. Shows a picture for 3.1L after 1993 from Autozone You also have to deal with a throttle cable housing right above it.



the location of the thermostat is under the throttle body.before you put it back on you need to buy some gasket sealer or a gasket for the thermostat




Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.