How do you replace the third brake LED light on a 2008 town and country?

Answer 1

Open the rear hatch and gently pull toward the glass the outside lip of the top piece of trim, it will snap out in about 8 places or tabs. remove the two 10mm nuts on the end of the top if the hatch and the two inside the holes in the middle. use a pair of needle nose pliers and squeeze and push the two white clips through other two holes in the middle,lower down the the rear gate and use a real long screwdriver or body panel tool and in the middle behind the third brake light there is another white body clip this one is tough. gently lift the plastic assembly and unhook the wire to the third brake light and twist and pull the washer supply hose the assembly should lift off. use a 5.5mm socket and remove the light fixture. installitation is the reverse