10 degrees BTDC
The timing specs for a 1988 Ford Mustang 2.3L can be found in the service manual for this vehicle. You can find this at many libraries as well as at a Ford dealership.
How to put manual transmission on mustang 1988
the timing specs are 17 to 18 degrees btdc.
www . motorcraft . com ( no spaces ) shows : Ignition timing ( 10 degrees BTDC ) for a 1988 Ford Mustang 5.0 L unless engine decal shows different
its an forgine peice of junk
Look on the sticker under the hood.
10 degrees BTDC ( unless engine compartment decal shows different )
Drivers side of the frame under the truck
Carb.? Float sticking? Rebuild or replace
You Can Put a 1988 Transmission In a 1993 Mustang Body.
You will need a timing light, set it at 10 degrees BTD
you have to take the timing belt cover off and timing belt to get to the water pump
I looked up a 1988 Ford Mustang 302 cubic inch ( high output ) and my Chilton book shows refer to the underhood sticker ( I know that my 1991 Ford Mustang 5.0 LX was 10 degrees BTDC )
The correct firing order is: 1-3-4-2
Get a manual on your car to do the job right. In short, you have to pull the timing belt covers and timing belt. Get a manual.
The horsepower in the 1988 Ford Mustang 5.0 was 225 horsepower
220 horsepower for the high output 302 in a 1988 Ford Mustang
how do you adjust the timing on a 1988 honda xr200
No, it has a timing chain.
how to do ignition timing on 1988 Toyota corolla fx
what is the ignition timing for a 1988 Chevy 454 engine
The horsepower on the 1988 Mustang was # 90 horsepower 2.3 liter engine # 225 horsepower 5.0 liter engine
Ignition timing or valve timing?