0
What else can I help you with?
Does head bolts have to be replaced after replacing head gasket on 1990 Honda accord?
Yes, replace the head bolts.
How do you replace the center brake light in a 1994 Honda Accord?
Look inside the trunk under the light for bolts to remove the light.
Which direction does a crankshaft pulley bolt come of on a 95 Honda accord?
crankshaft pulley bolt is left hand thread,so it will come out opposite direction to normal bolts
How do you locate and replace the exhaust manifold gasket on a 1987 Honda Accord DX?
The gasket is between the head and the manifold and simply remove the bolts and replace the gasket after cleaning it real good.
How to replace a valve cover gasket on a 1988 Honda Accord LX?
just remove the 3 bolts on top of the valve cover and lift it out,and theres the gasket.
How do you replace the low beam bulb on a 1997 Honda Accord LX 4-door?
Unscrew the Bolts, however there may be from the inside. Turn left to loosen then twist off and replace bulb.
What is the wheel bolt pattern for the 2002 Honda accord?
The wheel bolt pattern for the 2002 Honda Accord is 5x114.3. This means there are five bolts arranged in a circle with a diameter of 114.3 millimeters. The thread size is typically M12x1.5. Always verify with a reliable source or the vehicle's manual before making any changes to wheels.
How do you replace a starter for 1995 Honda Accord Lx?
follow the pos battery cable to find the starter. Remove the neg cable then the wires to the starter and the mounting bolts and work it out.
What size socket needed to remove starter bolts on a 1998 Honda Accord?
14mm
Do you have to change the timing belt in the 87 Honda Accord to replace the water pump?
You do not have to change the timing belt to replace the water pump. You do have to remove the timing belt cover to be able to access the bolts that hold the water pump on.
Which direction to turn to remove caliper bolts from 1990 Honda Accord?
Turn counterclockwise to remove them.
How do you replace the starter in a 1984 Honda Accord?
* Detach the negative battery cable * Clearly label then disconect the wires from the terminals on the starter motor and solenoid * Remove the mounting bolts and detach the starter
