First you must drain the coolant. Remove powersteering pump[keep hoses connected)this is just to make room for water pump removal so just sit it off to he side.Loosen the the water pump pulley mounting bolts, remove the drivebelt,remove the pump pulley. Remove the pump mounting bolts and pul the pump from engine.Install every thing in reverse ,but be sure to clean the mating surface of old sealer and gasket first, also be sure to use RTV gasket sealer on engine side of the new gasket.Be sure not to over/under tighten the bolts the torque specs. are 22 to 29 for the long bolts and 96 to132 for short bolts and 108 to 132 ft lb for the pulley bolts.
in the gas tank - lower the tank to replace
Its labled IGN
The 1994 eighty-eight royal randomly quits and then starts right away because of the mechanical fault.
I answered this yesterday, why is it back?
Probably cable
plug them back together
i need a little help with the rear brake pad
usually you don't. Use a socket wrench with an extra long handle or "breaker bar". Turn in the direction indicated on the tensioner, and the tensioner will move enough for you to remove the belt. Once the belt is off, you can remove the tensioner if you have to.
Oldsmobile never made a car named Royal Brougham
Could be many reasons. I would start with replacing the fuel filter and do a fuel pressure test.
No
To replace the fuel pump on a 1993 Oldsmobile 88 Royal LS, first, ensure the vehicle is safely elevated and disconnect the battery. Remove the fuel tank by detaching the fuel lines and support straps, then lower it carefully. Access the fuel pump by removing the retaining ring from the top of the tank, replace the old pump with the new one, reassemble the tank, and reconnect all lines and the battery. Finally, start the vehicle and check for leaks.