0
How do you replace the weedeater xt 110 spool of thread holder?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is thread holder?
the holder of a thread is called a spool
How do you reload a single string weedeater?
pop the spool out wind string in direction of arrow, replace
What is a spool pin?
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
How much is a spool of tread?
A spool of thread is very cheap. Spools of thread can be as cheap as a dollar or less a spool.
Where do you place the bobbin when you need to refill it with thread *?
place spool of thread on spool pin
How do you take apart the spool on a weedeater rte115?
The link to the manual is below
Feeds thread from spool to needle?
The thread moves from the spool through the needle to make stitches on a sewing machine. The thread take-up lever is what feeds the thread from the spool to the needle as it moves up and down.
What is a spool case?
a spoolcase is something that you use in sewing or when you sew you put the spool into a spoolcase but you must make sure the spool is filled up with thread then you can start sewing only if you have a long piece of thread in the spool!!
What part of speech is the word spool?
The word "spool" can function as a noun or a verb. It is a noun when referring to the object that holds thread, wire, or film, and a verb when describing the act of winding or unwinding thread onto a spool.
What is the collective nouns of thread?
A collective noun for thread is a spool of thread.
Where do you find a large spool holder and bobbins for a EuroPro 9106?
Sorry, I have no idea where you are, to suggest any place for you. But there are times when I need to hold a large 'cone' of thread at my sewing machine. Put the cone of thread in a large container, and running the thread through the 'eye' of a safety pin ( that you would tape to the sewing machine ) and run the thread past the stem where a spool of thread would normally sit, then thread the machine as usual. It works very well. I hope this is helpful for you.
How do you open the head to a weedeater to replace string?
On most of them you hold the top part with one hand and turn the bummer/spool clockwise (looking from the top)and pull it straight down/outward
