They are pressed in the hub so you have to knock them out. I use an air hammer with a flat tip hammering bit. when you install the new studs you slide them in the hole then use an OLD lug nut and with an air powered impact gun, screw the lug nut on the stud until the new stud is pulled tight in the hub, you want it to look like one of the old studs. MAKE SURE there is no gap between the hub and lug nut on the back side of the hub. Then torque to specifications. wich i belive is 115 ft lbs. but dont quote me....
To remove wheel studs from a 2000 Honda Civic the wheel needs to be removed. Taking the wheel hub completely off the vehicle makes the process of removing the studs easier. The studs are pressed in and use of a machine press to remove them is recommended.
Most of them just drive out. Get the new ones and you will see how they install.
No drop it from under the car.
A 1992 Honda Prelude is ( front wheel drive )
You have to have the hub pressed out of the knuckle to replace the wheel studs.
no
Honda Prelude 1979-1991 have the same bolt pattern so they will "fit". Then it just depends on the width of the wheel and the offset (the distance between the centerline of the wheel and the plane of the hub-mounting surface of the wheel). Honda Prelude 1992+ wheels will not fit.
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
you dont
5x114.3
yes
Yes the Honda Prelude.