I borrowed this from a buddy o mine.. more info here.. http://www.automotiveforums.com/vbulletin/showthread.php?t=902023 Ok, so put your top down. I THINK you need to remove the bottom door frame trim, next to the seat. It has like 5 rusted out screws that you may need to drill out. If you get the first 2 screws towards the back of the car, you could probably manage with that. Then, remove the back seat. You do this by digging your hands between the top and bottom half of the seat and pulling the bottom part out. Then it has some stupid clips in the front, holding the seat there. I think I broke my clips. But if you pull the seat up, so it's sitting vertically, you could probably stick a big flat head screwdriver into each clip and it should release them. Get the seat out. Then take off the upper seat, it has 2 bolts on the bottom and just slides off once the bolts are off. Then you need to work on the plastic panel, the one with the chrome clip that holds on the convertible boot cover. It also has the speaker on it. The screws are in plain sight once the seat is out. There's one screw on the boot cover clip. I think it may have a screw by the door frame too. The whole thing just picks up and you can swing it out of the way, or unplug the speaker and remove it completely. Now your window motor is visible... barely. I stopped here, but I noticed that it looked like the whole window regulator and motor are bolted on with about 4 or 5 bolts in plain sight, and I think you can take off the bolts and pull the whole assembly up. You'll probably have to unplug the motor about half way up though.
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
Knowing the way Chrysler often interchanges parts from many different cars, I would assume it would be about the same.
I was just searching the list and there is an answer to a similar question already in FAQ
On eBay there about $160 to $200 dependiing on if you need the rear window. You'll have to remove back seats to get at the complete convertible frame. The tops will come with instructions. Its a lot of work and very time consuming plan for a whole weekend.
how to repair passenger side window on a1986 Chrysler le baron
You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job
The rear window of your 1998 BMW 323 convertible can be replaced. Most BMW dealerships service department will replace the window.
the fender probably fills up with water. You need to make sure that the drain holes under the car are open. this shorts out the motors. then you need to access the motor and have it rebuilt or find a used one.
On the driverside frame rail.. under the rear door on a sedan.. or under the quarter window on a conv
Yes! If you have a zipout window. It will require top half open. Then the lower panel removal, re-stapling of the new meterial to the panel. Good luck tight fit.
I would use 100 % clear silicone, or Lexel.
the timing window is directly beneath the air filter housing, you must move/remove the air filter housing to see it