Remove the valve cover. Pry out the old gasket and clean the surface of the head where the gasket will touch it. Scrape out the groove where it was to get all the old glue out. Put a thin bead of anaerobic sealant into the gasket groove in the head cover. Set the gasket in place. Put it back on the head and tighten the bolts to 25 lb-ft - or "finger tight plus one turn"). This is a job that's easier done than said;
How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.
just remove the 3 bolts on top of the valve cover and lift it out,and theres the gasket.
usually the valve cover gasket and the oil seals on the top of the cover,replace gasket and the also the distributor seal
visit the parts store and look in the chilton manual for your make and model it should have the answers you seek
Check your crankcase ventilation, the hose or pcv may be blocked or disconnected.
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
Most probably, you have a valve cover gasket that is bad, and the oil is dripping down onto the exhaust manifold, and is being burned. Replace the valve cover gasket.
Replace the PCV Valve.
Oil on the outside of the spark plugs is caused by a leaking valve cover gasket. Replace the valve cover gasket. Oil on the electrode of the spark plugs indicates the engine is worn and is burning oil. The only fix for this is an engine rebuild.
Dear Honda owner, Valve cover leak? I assume you are refering to an external oil leak from the valve cover, replace the gasket, be sure the new gasket set comes with spark plug seals.
Remove the sparkplug cables, breather hose, and remove the valve cover. The gasket is a permanent type and comes as a 5 piece kit that simply pushes into groves in the valve cover. Once installed, replace the valve cover and connect the breather hoses and sparkplug cables.
If you see oil in the spark plug chambers in your Accord you will need to replace the vavle cover gasket. Oil from the top end of your engine (camshafts) is leaking through the vavle cover gaskets into one or more of the spark plug wells. Easy fix!!!!