I'm doing this now. It's a little daunting, because you have to take off the intake manifold. It's not particularly hard, it just takes time. It took me 4-5 hours to simply get everything taken apart. Lots of hoses and couplers to disconnect. You have to drain about 1/2 gallon of coolant from the radiator before you start.
Also, getting all of the gaskets was the hard part. I had to special order most from a Suzuki dealership. Total cost of gaskets: about $120. Gaskets you'll need:
- Intake manifold gaskets
- Valve cover gaskets
- Throttle body gasket (believe me, you'll need it)
- Surge tank pipe gaskets (2) (front pipe with two bolts on each side)
- Intake collector gaskets (2) (rear pipe with three bolts on each side, to which the throttle body is connected)
The valve cover gasket, on a 2004 Jeep liberty, can be found by removing the valve cover. Peel the gasket off of the head and replace with a new gasket.
how do you replace the valve cover gasket on a 2002 mitubishi lancer
The valve cover ask it, on a S 40 Volvo, can be replaced by first removing the valve cover. Remove the old gasket and replace with a new gasket.
how do you change valve cover gasket 2004 hyundai elantra
how to replace valve cover gasket toyota rav4 2001
To replace the valve cover gaskets on a 2003 Jeep Liberty, the valve cover is removed. The old gasket is then removed from both the valve cover and the manifold (old gasket will come off in pieces on both sides). Then spread the sealant on the manifold, place the new gasket on, then put sealant on top of the gasket and replace the valve cover and bolt down.
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.
see this site. www.ehow.com/how_4507846_replace-valve-cover-gasket-toyota.html - 51k -
How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.
you mean a valve cover gasket i think
To replace the valve cover, you will need to break the gasket and the o-rings. The gasket prevents oil from leaking.
take off valve cover throw away old gasket replace old gasket with new put valve cover back on pwn