start by unbolting crossover exhaust pipes from manifold. take of cross member and skid plates. disassemble driveshafts to front axle. take main trans bolts out. drop the trans down change starter, reverse order. or take passenger wheel tire off try it that way but i do it the other way to check clutch pltes and check grease fittings and fill.
does that year have carb or tb?
89-94 chevy blazer with 2.8
yes
how do you get the limited-slip rear end on a 1990 Chevy blazer k-5 apart
It is bolted to top of starter.
It is mounted on the top of the starter.
== ==
i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.
I just replaced the starter motor on my 1990 4 cylinder engine Chevy Lumina. The starter is located in front of the oil pan. It was reachable and can be seen from under the front of the car a little to the right. You have to remove a three bolt attached plastic part by the oil pan to be able to get to one of the starter motor bolts. Good luck.
If you are looking for the starter solenoid, it is attached to the starter.
It sounds like you need to get your starter motor, repaired, reconditioned or replaced. I had this problem a few months ago, but since getting it reconditioned, it's working perfectly again !
Dextron II