A maximum of four remote controls are allowed to be programmed. Ensure all the doors have been unlocked, either by using a good transponder key or remote control plip key. 1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds. 2. Then turn ignition switch to OFF position. Leave key in ignition switch. 3. After 2 seconds, the system will enter programming mode and will flash the warning lights twice. 4. Press and HOLD the unlock button on the Plip. 5. While pressing the unlock button, press the lock button 3 times. 6. Release the unlock button. 7. The warning lights will flash once to indicate successful programming. 8. Repeat procedure 4 to 7 for up to 4 plip key's. 9. When completed turn ignition ON, and the warning lights will flash 2 times. 10. Remove key, and check all plip key's for operation. NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys have been programmed or no input signal either from the switch or plip keys has been received for 120 seconds.
in the key
You don't that's why there's a key.
You normally do not have to reprogram the key when you replace the battery. If you do you will have to contact your VW dealer.
Turn the key at the door towards the front of the car
Check to see if you are using the correct key, the 2002 Nissan Xterra has a chip in the key, but it also comes with a valet key. If the valet key accidentally gets placed in the ignition it will not crank, on some vehicles it completely shuts the vehicle down and you have to get it towed into the dealership, try using the other key that came with your vehicle.
You need to reprogram your key to the car vin.. The dealer knows about this.. Enjoy the xterra
I believe it's 17 mm wrench, not Allen key.
To turn off the alarm, you insert the the key in the drivers door lock and turn the key to the right two times.
you will need to go to a main dealer to get it reprogram it
No
Programmer and PIN code required
I just replaced the ECM in my 2005 Escape & I did have to have a Locksmith come out & REPROGRAM the Key Codes into the computer. When You turn on your ignition, the red THEFT light will probably start flashing fast & the engine will not turn over. This means it doesnt like your key. Time to call the Locksmith or drag it to the dealership to get it reprogrammed.