This sounds crazy but I think you have to have the drivers door open and hit lock and unlock button 10 times if I remember correctly.
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
remove negative battery cable for 15 minutes
Disconnect the battery, push the brake pedal down and count to 30. Reconnect the battery, and the ECU is now reset.
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
Unbolt the battery for at least ten seconds. Mechanic, Why are the parking lights flashing after new battery installation?
You can disconnect the battery. This kills the codes. However, if there still is a problem, the light will come back after a certain number of driven miles. Besides, if you erase the codes before an inspection the inspector's code reader will see that you have done it and may turn you away for not readiness.
There is nothing to reset except the radio presets and the clock.
There is nothing to reset. Just change the battery and if you have it in correctly it will work.
There is a small black button hanging down just above gas peddel under your dash to reset this problem. You have to hold it in till you hear all the door locks reset ,then your lights will stop flashing.
Disconet the battery for 15 minutes this will reset your oil change light
You do not have to reset the computer. It will take care of itself.
Need to reset computer...