Just disconnect the battery for about 5 minutes. It will wipe out the memory for codes and start you fresh. Only drawback is you'll have to reset your radio station presets and maybe some other creature comforts. The other thing you can try is find out what fuse controls that system/item pull it out for about the same time and it may reset the fault memory for that system.
Is it dangerous to drive the vehicle with this message
The 4wd message in a Chevy Suburban is most commonly caused by the encoder motor or the selector switch failing. The transmission computer codes should be run to see if an indicated.
means you shold drive a ford
The service stability system message on your 2003 Cadillac CTS usually refers to a problem in your braking system. The problem should be addressed immediately.
replace fuse or rear shocks
Read your owners manual.
To reset the service light. First press the button on the control stalk until the survive due message appears. Then you must press and hold the same button until the message stars to flash. Continue to hold the button until it resets and you get a new message xxxxx miles to next service.
cycle thur the check control messages in the disply using the turn signal stalk knob, when u get to the oil service due message, press and hold the bc button. You should get a reset service message displayed.
A message left on an answer machine or call minder service. It can be played back by contacting your message service, or operating your answer machine.
SMS Stands For: Short Message Service...
I had the problem on my 04 esv I had to replace the rear suspension air pump
The procedure will vary from year to year to bypass the service ride control, but the basics are the same. Put the unit into program mode (look in your owners manual.) Set the default to 0. With the default of 0 the light should stay off.