There are 2 ways to do this. #1- go to autozone, and ask them to do it for you. THey will take an obdII reader out there an erase the codes.
#2-disconnect your negative (most likely black) power cable from the battery, and give it a half hour for all of the memory in your car to erase. Read you owners manual on battery failure...it will tell you how to reset your idle conditionas and perameters.
Most any code reader that plugs into diagnostic port can reset
Repair the problem and it will typically reset itself after 3 starting cycles.
stop by local parts store they should have a little ob sensor that would reset it
disconnect neg and pos of battery for 1 minute
You can try disconnecting the negative battery cable for 5 minutes. That may reset the light. If not you will need an OBD2 scan tool to reset it.
you need access to an OBDII scan tool in order to reset the check engine light on any vehicle 1996 or newer. autozone or advanced auto usually provide this service for free
Try disconnecting the battery for 1 hour. This should reset the check engine light on this vehicle as it is OBD1.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
how do i reset the check engine light on a 1999 acura 3.2tl
hoe do you reset the check engine light in a 1995 land rover