0
First you must turn your key on to the start position without starting the car and then you must press the gas pedal to the floor three times in less than ten seconds. Turn the key back to the off position and the light should reset, If this doesn't work try the procedure again.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you reset oil change light on Chrysler grand voyager 1997?
how do you reset change oil light on chrysler grand voyager minivan 1997
How do you reset the change oil light in a 2012 Chrysler 300?
Key on engine off. Press the gas pedal to the floor three times.
How do you reset the change oil light on a 2011 Chrysler 300?
Key on engine off, press gas pedal to the floor three times
How many quarts of oil for an oil change in a Chrysler 300 v6 3.5 engine?
6
How much oil does a 1999 chrysler 300 hold with oil and filter change?
5.255.25
How do you reset oil change display on 2008 chrysler 300?
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
When do you change oil in a 2006 Chrysler 300?
Every 3000-5000 miles
What weight of oil do you use for an oil change in a 2006 Chrysler 300 c hemi 5.7?
5w20
Where is the oil reset switch chrysler 300 2008?
To reset the oil change due message,Turn the ignition on, press the gas pedal to the floor three times, cycle key off and on.To reset the oil change due message,Turn the ignition on, press the gas pedal to the floor three times, cycle key off and on.
How do you reset the maintenance light after an oil change on a 2010 Chrysler Sebring?
The oil change light is reset by Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
How often should you get an oil change on a Chrysler 300?
If you use conventional oil then I recommend you change the oil/filter every 5,000 miles. If you use synthetic then change it every 8,000 miles.
How do you reset check engine light after an oil change on a Chrysler?
The check engine light does not come on when an oil change is due. The check engine light is for an emissions related failure. It is reset with a scan tool after the fault is repaired.
