Best Answer

Put the key in the ignition, and turn forward

all the way just before cranking. Then within

5 seconds, locate, press and hold in the

valet/overide button, found under the

dash area, (push button, spring loaded)

until the installed LED (the blinking light)

in your dash area goes on solid,

and the siren chirps once.

This should reset the alarm, and reset

the grounded relay on the starter wire,

allowing you to start the engine.

User Avatar

Wiki User

โˆ™ 2008-01-03 15:11:57
This answer is:
User Avatar
Study guides

Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you reset a car alarm lockout on a 1996 Toyota Corolla?
Write your answer...
Related questions

How do you reset a car alarm lockout on a 1999 Toyota Solara?

how do you reset alarm after rplacing the battery on 1999 toyota solara

How do you reset your 1997 Toyota Corolla VIP alarm so it will start again?


How do you reset maintenance light on Toyota Corolla 2010?

How do you reset maint read light on 2010 corolla

How do you reset air bag light on a 2003 Toyota Corolla?

my2003 toyota corolla the airbag light is on

How do you reset the Toyota Tundra factory alarm?

In most cases the Toyota tundra factory alarm will reset itself after 10 minutes. You can also pull the fuse out for 10 seconds and replace it to reset the alarm.

How do you reset the alarm on a corolla 1993?

To reset the alarm on a Corolla 1993, place they key in the ignition and turn it until it clicks. Keep the key in this position for 10 minutes and then start the car as normal.

How do you reset Toyota Corolla engine immobilizer?

buy a ford

How to reset alarm for 94 corolla after changing battery?

To reset an alarm for a 94 Corolla after changing the battery, place the key in the ignition and turn it slightly. Let it remain in that position for several minutes before starting the car.

How do you reset alarm on Toyota Corolla 1999?

First remove battery cable. Second install your key and turn it to on. Third reinstall battery and all should be fine.

Where is reset button for fuel pump on a 1997 Toyota corolla?

There is none.

Where is the alarm reset button on a 2006 Toyota tacoma?

how to locate the anti theft reset

Where is the maint reset button on a 2008 corolla?

Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla

Where do you find the Fuel reset button for a 2004 Toyota corolla?

Owner's manual.

How should you reset tire pressure sensor in Toyota Corolla 1997 AE 110?

indicator can't reset

How do you reset fob for 2001 Toyota Avalon?

Car alarm goes off for no reason on 2001 Toyota Avalon. Is there is a reset button to solve this problem?

How do you reset the average mpg display on a Toyota Corolla?

on my 2010 - push and hold the button

Car alarm reset button for Toyota Sienna?

I have a Toyota sienna 2003 van, LED of the car alarm keeps blinking even I deactivate it to open the doors . Please tell me how to reset it? thanks Peter

How do you reset the oil change light on a Toyota Corolla verso?

Resetting the oil light on a Toyota Corolla Verso is very easy to do. You just need to take the battery cables off the battery for a few minutes and then put them back on. This will reset the oil change light.

Where is the button on a 1995 Toyota corolla to reset the malfunction indicator lamp?

its on your rear end and armpit loser hair

Reset check engine light 1996 Toyota corolla?

Go to Autozone or Advance Auto and borrow their OBD2 scanner and reset it. Easy and free to use

How can you reset the airbag light on a 1993 Toyota Corolla?

You will first need to check that the airbag has been properly set up. Then you can go into your settings and get it all reset.

How do you reset the security alarm for a Toyota Sienna?

If the alarm is going off, you should press the panic button again. You can also get inside and turn on the car to turn the alarm off.

How do you reset alarm on Pontiac transport?

how to reset alarm

How can you reset your 2006 Toyota coralla check engine light?

To reset the check engine light in your 2006 Toyota Corolla, you will need to attach the car to a diagnostic computer. This allows you to pinpoint the reason for the light coming on, select the correct sensor, and reset the light.

How do you reset alarm on 2005 Toyota sequoia?

Put key in ignition and then turn on/off 3 times.