Usually aproblem in the emission control system - have vehicle scanned to determine problem and have codes cleared
hoe do you reset the check engine light in a 1995 land rover
You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.
Disconnect the battery for about 1 min.
reset service engine light
the only way to reset is to have a t4 testbook computer do it at the dealer or jag shop yes if it is the orange check engine light it must be reset with a t4 but if it is the red service engine light this is just a reminder light telling you that after 75,000 miles you should replace youre o2 sensors.under the drivers seat you will find a brown relay box on the top is a sticker with the land rover logo.Stick a straight pick through the Land Rover emblem until it wont go any further down.The light will never bother you again
There is NO reset button for the Check Engine Light. The light is on because there is a problem with the emissions controls. The ECU has triggered the light to stay on, and has set one or more fault codes. To access the codes you will need an OBD2 scanner. Once the problem is repaired you use the same scanner to reset the light. Resetting the CE light without repairing the problem will do not good as it will just come back on.
Gonna have to buy the Range Rover software and adapter so you can connect your computer to the ECU. or take it to the dealership, going to cost money either way.
to reset you have to press the button that says doodlebops
you have to take to a rover dealer to put out the service light
The check engine light can come on for a variety of reasons. You will have to have the vehicle connected to a code reader to determine the specific reason for the light to be on.
iT WILL RESET WHEN THE PROBLEM IS REPAIRED.
range rover supercharge service light off