We just had ours reset today and the guy used a computer hooked up to our car. He told us the is the only way to do it. I'm thinking you should be able to unhook the battery though. Make sure you have all your codes before doing this though.
how do i reset the check engine light on a 1999 acura 3.2tl
check engine light reset on a 1999 acura cl 3.0.. Just replaced the egr valve. Thx
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
u do a poo
Disconnect the Battery for 5 minutes
After repairing the cause of the code, you reset it with a scan tool.
remove the alternator fuse for 20 seconds.
Have vehicle scanned to determine problem and have codes cleared
take it to your mechanic so he can run a diagnostic.
Remove the negative battery terminal for three minutes.
A handheld scan at $99 from Canadian Tire will do the trick.
Have vehicle scanned to determine the problem and/or have codes cleared
Disconnect the negative terminal to the battery for 3 min.. It worked for me :)
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light comes on when a problem has been detected, you have to fix the problem to get the light to turn off. You can have the problem code read at most auto parts stores for free. To reset the light, disconnect the battery for one minute.
You reset the check engine light with a scan tool after repairing the failure.
The check engine light has to be reset with a OBD scan tool
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
The check engine light can be reset two ways. 1) If the problem resolves itself, the check engine light will reset itself after a certain amount of cold starts of the car on the on board computer system. 2) You need an OBD reader that has the reset check engine light capability.