you can't reset the brake light the computer automatically detects problems so if it hasn't shut off after a few engine cycles there is a problem with your braking system
Have the SRS repaired by a qualified technician and they will reset the light.
Add brake oil
The brake light switch is bad. It's under the dash, and is switched by the movement of the brake pedal.
after the cause of the code is repaired, you reset with a scan tool, or by unhooking the battery.
To reset the maintenance light on a 2000 Jeep Grand Cherokee, turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within ten seconds, then turn off the ignition. Start the vehicle to ensure the maintenance light has reset. If the light remains on, repeat the process.
How do i replace brake lines on a 2000 grand am
You need to check the wiring for power to the bulbs.
To reset the service engine light in a 2000 Suzuki Grand Vitara, you can disconnect the negative battery terminal for about 15 minutes. This will clear the engine codes and reset the light. Alternatively, you can use an OBD-II scanner to read and clear the codes directly. Always ensure that any underlying issues causing the light to activate are addressed before resetting it.
To reset the brake lamp indicator on a 2000 Acura TL, first ensure that the brake lights are functioning properly. If they are, disconnect the negative terminal of the battery for about 10 minutes to reset the system. Reconnect the battery and check if the indicator has cleared. If the light remains on, it may indicate a more serious issue that requires further diagnosis.
how to reset abs warning light on 2000 gmc Yukon
Does not have one.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.