How do you reset check engine indicator for 1995 Lexus ES300?
Remove the negative battery cable for 30 seconds.
Or you can remove the fuse in the under-the-hood fuse panel marked "EFI" for 10 seconds. This works on most all Lexus models from 90-95.
You can disconnect the battery terminal, wait 10 seconds and then re-connect, this will reset the onboard computer and the check engine light will go out. However, this only resets the computer and does not solve the underlying problem with the vehicle. To correct the problem the code will have to read by a scanner and this will give some idea as to the problem with the vehicle.
Why does the check engine light still come on even after you changed the O2 sensor and reset the check engine light on a 1996 Lexus ES300?
IT IS LOCATED UNDER THE ENGINE COVER, THER WILL BE A HOSE CONNECTED TO IT. TAKE TEH ENGINE COVER OFF WITH 10MM SOCKET. IT IS LOCATED UNDER THERE NEAR THE FIREWALL. Have you heard the phrase a picture is worth 1000 words? The picture of this vehicle will help you find your pcv valve. Check it out: http://www.clublexus.com/forums/es300-and-es330-forum/418700-2001-lexus-es300-pcv-where-is-it.html
Are the struts that hold up the front hood of a1994 Lexus es300 repairable when they fail or do they have to be replaced?
I took my car to change the oil and after that the check engine light came on and the car bucked at low speed. I finally found that the large tube that went from the air filter to the throdle body had a large crack in it and was causing the problem. I did a code scan on my 1994 Lexus es300 and it showed that a O2 sensor was bad but the new hosefixed…
Look 1st at the simple solutions I would check that the wire from the indicator is actually attached to the thermo (top of engine block) otherwise I would check the thermo is working! Look 1st at the simple solutions I would check that the wire from the indicator is actually attached to the thermo (top of engine block) otherwise I would check the thermo is working!
Check engine or sometimes called MIL (malfunction indicator light) is mainly related to emissions. The TOP reasons are oxygen sensors and smog related items. Unplug your negative battery post for a minute or two and see how long it takes for the light to come on again. On mine it was a sensor and came on within about 3-5 miles of city driving.
What causes 1992 Lexus es300 overheating the cooling fan has stopped coming on and the fuse is not out?
In the 1992 Lexus ES300 there is only one cooling fan. The cooling fan is operated hydraulically by fluid from the power steering reservoir. If there is a leak in the fluid pipe the fan can stop working and the car will over heat in traffic, otherwise it is fine. In any case the fan MUST always run when the A/C is switched on. Check for leaks in the rubber hose leading to the cooling…
I have a Lexus 96 es300. There are three oxygen sensors on this car. All the sensors are on the exhaust pipe. The first oxygen sensor which is in front of the engine when you open the hood called (bank # 2). The second sensor locates between the back side of the engine and the wall called ( bank # 1). It is very hard to replace if you have a big hand b/c there…