Either hook up a scan too and clear it, or disconnect battery for a minute. Either way if the fault is still there the light will come on after the car completes a series of tests called a drive cycle. If those tests are not complete, regardless of light status the car will not pass an emissions inspection.
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
Assuming you want to clear/reset the check engine light, if you have successfully made repairs to correct what was the cause of the check engine light to go on the light will clear itself after a few drive cycles.
The check engine light problem will have to be repaired in order to have someone with a scanner to reset it. If the repair is not made then the light will come back on immediately.
Fix the problem and hook up a tech 2 to it and clear codes
Disconnect the red terminal on battery and let it sit for 15-30 minutes, reconnect the battery and check engine light should be off because the computer has been reset.
With an automotive computer or they'll do it for free at any AutoZone or PepBoys, or any automotive store.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
Use an OBD scan tool to reset or disconnect the battery
hoe do you reset the check engine light in a 1995 land rover