Try removing negative battery cable for 10 minutes. If that does not work you will need an OBD2 scan tool to reset the light. I just cleaned my egr valve and the check engine light went off and I drove it a little and it came back on how long do I have to drive my car after work with the egr valve how many miles
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
Just unplug the negative terminal of the battery for about 10 minutes and that will reset the computer
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
You can not reset your oxygen sensors. You can only replace them. To reset the check engine light you will have to get that done by a repair shop with a computor. If replacing the sensors does not repair the problem then check for a vacuum leak.
Remove the negative power line to the battery. Wait a few seconds and replace. That will reset the check engine light. darksidesteve
disconnect the negative battery cable for 30 seconds
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?