0
Unplug the one pin ECM power connector attached to the positive battery cable. It is usually hidden underneath the power brake booster. Open the connection for a few seconds and then reconnect.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the fuel pump reset switch on a 1989 Corvette automatic?
= Where is the fuel pump reset switch on a 1989 corvette automatic? =
How do you reset computer in Corvette?
The computer in a Corvette model is responsible for notifying the driver of several things. It can be reset by disconnecting the battery.
How do you reset computer 1992 Corvette?
Sometimes the computer of a car can become messed up. To reset a computer, one must find a car dealership that has the device to reset the computer.
Where's the computer on the 1989 Corvette?
the computer is under the dash on the passenger side
How do you reset the change oil light on a 2000 corvette?
oil servis reset without using a computer http://www.kofla.net/chevrolet.htm
How do you reset computer on a 1989 Mercury Cougar?
Disconnect the vehicles battery. Leave it unhooked for several hours. Reconnect the battery. This should reset the 1989 cougars computer.
How can you reset the computer on a 1998 Corvette?
Disconnect the battery for about 5 minutes then hook it back up.
How do you reset the computer on a 1989 corvette?
Unplug the one pin ECM power connector attached to the positive battery cable. It is usually hidden underneath the power brake booster. Open the connection for a few seconds and then reconnect.
How do you reset the oil change light on a 1992 Corvette?
== == how do you reset the oil light on a1992 corvette
How do you reset ECM 1989 Festiva?
Unplug you battery for 20 to 25 minutes that should reset you computer.
What is the reset procedure for a 1992 Corvette after changing batteries?
Computer should restore all the settings after driving for a while.
How do you reset the check engine light in a 1989 corvette?
You can reset the light by disconnecting the battery for 10 minutes. It will come back on again if you do not correct the problem that set the light in the first place.
