== == how do you reset the oil light on a1992 corvette
The courtesy lightsÊon your 1992 Corvette is on the bottom side of the rear-view mirror. However, there is no light delay switch as the lights can easily be turned on or off.Ê
Sometimes the computer of a car can become messed up. To reset a computer, one must find a car dealership that has the device to reset the computer.
press the oil button then press the reset button hold for five seconds it will reset oil life monitor back to 100%
Computer should restore all the settings after driving for a while.
The maintenance required light requires a scan tool to be reset.
where is the fuse that controls the antenna to a 1992 corvette?
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
Sounds like it may have been replaced at one point with an inferior piece.
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
You will need to go to a repair shop and have them scan for codes. That will tell them the problem and when it is repaired they can reset the light.
yes they will
There is a small black slot on the left of the guage cluster. Put your car key in there, it should reset the light!
Yes, they are a direct fit. TOM
also try to change the oil. Try disconnecting the batery for 15 minutes. The computer will reset itself. This worked on a '95 Thunderbird. To reset the oil light, put the key in the ignition and turn to accessory setting (but do not start the car) Push the English/Metric button twice and then push and hold the "Gauges" button. The "Change Oil" light will flash for about 15-20 seconds and then go out. Release the button and turn key off. When you turn the key back on, the light should be out. If it is not, repeat the above steps. Try changing the freaking oil!!!!!!!! That might help!!! I'm just saying!!!!!
can byou buy a permanent in-line fuel gauge for a 1992 corvette
A scan tool is required.
how to reset check engine light on 1992 Mazda mpv
Try disconnecting the battery for 1 hour. This should reset the check engine light on this vehicle as it is OBD1.
A 1992 Regency has an OBD I system. The easiest way to reset a service engine soon light is to disconnect the battery and leave it disconnected for a minute or two. You will lose all of your radio presets though. CAUTION: Make sure that the problem is fixed before you reset the light because it will probably come back on.
Working on the Air Bags (SRS) can be very dangerous. Take it to a professional for repair. They will reset the light. Resetting the light without repairing the problem will do not good as it will just come back on.
Remove the positive battery terminal for 30 minutes. This will reset the light on this OBD1 vehicle. But remember that unless you repair the problem that set the light in the first place it will just come back on.