read your codes like for a cel and erase them using the erase function?If so there is the
This generic OBDII drive cycle
Begin with a cold start (coolant temperature below 122 degrees F and the coolant and air temperature sensors within 11 degrees of one another). This condition can be achieved by allowing the vehicle to "sit" overnight, and then by beginning the drive cycle the next day. Most drive cycles will be difficult to follow exactly under normal driving conditions, so the driver should exercise caution, road safety, and courtesy to others.
* Start the engine. Idle the engine in drive for two and a half minutes with the A/C and rear defroster on.
* Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle.
* Hold at a steady speed of 55 mph for three minutes.
* Decelerate (coast down) to 20 mph without braking or depressing the clutch.
* Accelerate back to 55 to 60 mph at ¾ throttle.
* Hold at a steady speed of 55 to 60 mph for five minutes.
* Decelerate (coast down) to a stop without braking.
how to reset the oil light on a 1997 mercedes e420
if the light came on and stayed on you can clear it by unhooking the battery to reset it. however if you did not fix the problem after you go through a drive cycle on your car it will come back on. the time for a drive cycle varies for each car.
hi how i can load the maps to GPS in E320 1997
Try disconecting the battery for a couple minutes,it worked for me..
inside the oil pan,with drive chain. https://sites.google.com/site/autobestanswer/mercedes
check out www . motorcraft service . com click on Owner Guides The drive cycle is shown in the owners manual
u can rest ur engine timing just take cables of battries for one houre then it will be automaticly rest
There is nothing to reset. You already reset the PCM back to factory settings when you disconnected the battery to replace it. Now you must drive the vehicle normally so it will relearn your driving habits, conditions you drive under, climate, etc.
If it is the same as my 95 LS then drive to a clear parking lot, fully depress, then release the "S" reset button (you may need to use a ballpoint pen) on the front of the compass and drive slowly in a clockwise circle 3 times. That should reset it.
how to reset the computer on a 1997 ford expedition
150 you would be safe, could be as little as 75
what would be the cost of registration on a 1997 Mercedes Benz c280