I am not 100% sure this will work on a tC, but i have an xA and this trick works on almost ALL Toyota's made after 2000
insert key, and turn to "ON" position.
Look at odometer, make sure its on ODO and not TRIP1, or TRIP2
turn the key to the "OFF" position.
press and hold the trip reset button (the only button on the odometer)
while holding, turn key to "ON" position again.
The odometer will show blinking bars, succeeding from right to left. once all bars have succeeded, it will say "000000000"
Your MIL has been rset.
Turn your key to "OFF" position, then back, and start your car.
The MIL light should be off.
(NOTE: this does not reset the CEL, just the MIL. the CEL or Check Engine Light cannot be reset without using an OBDII interface, or a hard reset by removing the battery cable. This technique should only be used when preforming a full service, or an oil change.)
how do i reset srs light on scion tc
You will find that info in the owners manual.
how do i reset srs light on scion tc
change the oil
You have a defective airbag. You replace that bag.
With the key "off", push and hold the odometer reset button. With your other hand, turn the key to the "On" position. The odometer will count down dashes(-) and then display 000000. Let go of the odometer reset button. Turn key off and then on and start the engine. "Maint. Required" light should stay off
1. Set your ODO to Trip A 2. Turn off ignition 3. Hold ODO button 4. Turn on ignition 5. Hold ODO button until Maintenance Required light stops flashing
t's not a problem, it is merely a reminder light so customers will be prompted to do the required maintenance. Turn the ignition ON Make sure the "ODO" is displayed, not "TRIP" Press and hold the TRIP reset button Turn the key off and back on Hold the reset button until the lines on the ODO display disappear and the ODOMETER reading comes back. answered by Liselle
Go see a mechanic. You may have a serious problem. Don't mess with brakes.
The maintenance required light requires a scan tool to be reset.
It means its time for an oil change. Can be reset by pushing the trip button until its on ODO. then hold the trip button, turn off the car and turn key to the on position without starting the car, then releasing the trip button. should reset from there.
aperantly take the light out