Want this question answered?
On my 2010 you just hit reset to clear it off of the screen, then hit setup a few times 'til you get to the oil % screen, then hold reset for 2 seconds.
You fill the washer fluid reservoir.
what does a line under a car signal mean
The owners manual from my 2010 Ford Edge Limited states that you must drive the vehicle for 2 minutes at over 20 mph before the warning light will reset.
( 5.3 quarts ) with engine oil filter change for the 2.5 liter four cylinder in a 2010 Ford Escape , according to the Owner Guide
You can reset the change oil light on your 2010 Nissan Ultima by going to the oil life display. When the oil life display is illuminated hold in the checkmark button until the oil life goes to 100 percent.
The oil change light is reset by Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
Mine, a 2010 1.4 TSI VRS has a button down by the hand brake. Hold it for a couple of seconds
you need to take the old oil out. Then put the new oil in.
The 2010 Ford Escape has 16 valves.
reset service light on 2010 ml 550
this can only be done at a mitsubishi dealers service department