with the ignition off press and hold the miles reset button in on dash now turn on ignition and start engine 'service now' should now be displayed now turn the clock adjuster button either left or right and this should rest the service noification.
CHECK
This could mean that your car is due for service , on the Sharan 1.8t the oil light needs to be reset after service, you find the reset plug to which you connect the device to reset the light under the ash-tray. Or, it coud that the oil pump is mulfunctioning, there is not enough system oil pressure.
Press the step button until zero miles to service is displayed. Press and hold reset.
That can only be done by a service tech, the car is so new that it will not reset even if you disconnect the battery**the above is incorrect.To reset the service light, turn ignition switch to ON position with engine off. Observe speedometer display and tachometer multifunction display. When standard display appears press up or down arrow on the multifunction steering wheel until the FSS service indicator with one or two wrenches appears in speedometer display and service deadline appears in tachometer display.Now, press the reset button between the speedometer and the tachometer for about 4 seconds or until the tachometer display shows "Do you want to reset service interval? Confirm by using the reset button" To confirm hold down the reset button again until a signal is heard. the service indicator will display the reset interval. Reset is complete.
2009
Move through the overhead display to where it says perform service. Hold down the Reset button for a few seconds and it will reset to "3,000 miles to service"
With the ignition on hold down the mileage reste button until you get 4 dashes or use the socket under the ash tray to connect the vag reset tool.
Answer : to reset the display do the following : with the ignition switched off, press and hold the trip meter reset button below the speedometer. Switch the ignition on and hold the reset buttton for at least 10 seconds. Dashes appear in the display. The service has been reset.
You can reset the service light by bringing of the oil life monitor on your display. Hold the scroll button in until the oil life goes to 100 percent. This should reset your service light.
I Think its a main dealer job only as they use a guided function with the Audi VAS computer to reset the service display
Button A = Button on the right of the centre display on the console Button B = Button on the left of the centre display on the console Ignition off. Press and hold down button "A" Ignition on. The word "SERVICE" will appear in the trip computer display Turn button "B" to the right to reset the display Turn Ignition off.
For the service light, Switch ignition on, The display will flash for 2 seconds, press the button next to fuel gauge until "----" appeares in the display, Release the button and switch the ignition off, and that should reset the light for you,